Chesbay.net - improving tag

Barber Hauling on Close Reaches

Wed, 08 Sep 2010 14:02:00 GMT

A useful, but sometimes forgotten technique when reaching under a genoa is to Barber-haul the tack out and open up the slot.

Improving as a Racer; Part 3, Heel Angle and Balance

Thu, 25 Feb 2010 21:19:00 GMT

Unless you are sailing a high-end boat with water ballast or a movable keel (in which case, you probably aren't reading this anyway), then a key aspect of getting faster is adjusting the balance of the boat side-to-side and fore-and aft. How do we do this?

Side-to-side balance is usually called "heel" or heel angle. There is a common mis-perception among racers starting out that more heel is a good thing. When the boat heels over and digs in with the rail in the water, we feel like we're really sailing - flying along! Although this is a lot of fun, It's not necessarily good speed. Buddy Melges said that each boat has a designed heel angle and that part of our goal as racers is to keep the boat at that angle (I'm paraphrasing). From hull-design perspective, there is an underwater shape the boat designer is trying to move through the water and we have to achieve that shape.

This can be very hard to do, especially in chop, but there are a lot of tools at our disposal. But first off, know what your ideal heel angle should be. If you can't get that the designed angle, develop it by sailing, adjusting the heel and watching your speed. Most modern boats don't sail well if heeled more than 20 degrees.

In light air, the boat won't heel much from the wind. So we move crew weight to the low side of the boat. This induces heel which helps achieve that underwater shape and also allows the sails to "fall" into some kind of airfoil shape - with the boat heeling, gravity pulls the sails into shape. Well, sort of. But better than without heel. Ideally, in very light air, we would sail with a lot fewer crew. It just takes less person-power to handle the boat. But, in reality, sailing is a social occasion and I don't think about leaving folks on the dock. So put them on the low side.

As the wind picks up a little (still light, but moving), crew weight can come back towards the boat center. Ideally, as the wind strengthens and lightens, the crew will automatically move in and out, balancing the boat as needed.

And as the wind strengthens so that we are heeling because of it, crew will move to the windward, or "high" side of the boat and help hold her down. The crew on the rail should "hike", ensuring that as the boat heels more, they are sitting with legs and even arms and torso outside the lifelines - weight outboard and hiking hard! Again, in the ideal world, we would carry more crew on heavy air days. And I certainly try to do that if I know in advance that the winds are expected to be strong. But beware of it dying off as it frequently does in the evenings.

And finally, as the crew is all on the high-side rail, hiking hard, we need to start depowering the sails. That's a whole separate subject. But I'll say this much here; easing the traveler is the traditional way to reduce power on the mainsail, but I don't use it until the boat is almost out of control. It's not the first line of defense, in my opinion. If we think of the mast as a huge lever, then the most effective way to reduce heel is to take away force at the end of the lever - at the top of the mast. This means adding backstay tension and easing the genoa lead cars, if your boat has these. Do this first, ease the traveler second (or third). And finally, when the wind is overpowering, the crew is on the rail and the wind is still strengthening (or holding), we shorten sail - shift to a smaller jib and/or reef.

All of this thinking is the same for multihull boats as it is for monohulls, but the techniques may differ in how you deal with the "heel". Multihull boats often go faster with a hull out of the water (flying a hull), so the balancing act is aimed around getting a hull flying. But the principles are the same - just applied differently.

Also important to the balance of the boat is fore-aft trim. It's very easy to keep too much weight in the aft part of the boat, especially a boat used for cruising as well as racing. Empty out that lazarette! But also, try to keep the crew weight positioned fore-and-aft so as to keep the boat on her lines. Generally, (not always), this means that upwind and in lighter air, crew will sit further forward. This helps to get the aft underwater portions of the hull up leaving less hull in the water. In heavier upwind sailing, crew weight will be more midships (almost never aft). In some upper-echelon regattas I've had crew go below to sit over the keel; but that's a bit extreme for a Wednesday night. Downwind, crew would hang out mostly forward, except in really heavy air. Then crew weight aft helps hold the stern down and the rudder in the water. It also helps catch waves for surfing.

Improving as a Racer, Part 2.5, More on the Sails

Wed, 24 Feb 2010 18:09:00 GMT

A big question is how "good" do the sails need to be for a developing sailor. And how do we know? I want to be able to say something like "ignore high-tech fabrics" or "Go to a used-sail loft" or something. But I'm realizing it isn't that simple; the question is unanswerable as a general case.

Basically, we have to have equipment that is as good as the top rung of the ladder we want to climb. The ladder is our ruler, we measure performance against the fleet. So first question is, "can my team manage the boat around the race course and perform the standard maneuvers"? At that point we need sails that keep us in competition with the fleet. When everything is settled and we're hanging with our part of the pecking order in the fleet and our power and boat speed are equal. But, the sails have to work so that we can change gears as needed. Usually that's not a cheap sail. Depending in our fleet and it's competetiveness and culture, that may well mean new sails every year.

But, can I really SEE the difference between good and great sails (as determined by the fleet culture). If I can, I should go for them because it's my passion; why would I short change myself. And I can copy the way the top of the fleet set up.
But with that advice comes this: don't think that we'll necessarily win or get the most out of those sails. Time on the water is the coin that matters. Time on the water means that we'll be able to pull the strings to get the sail shaped correct for the conditions. If we have a lesser sail, it's much harder to see the effect of getting it set properly.

As an example, one of our competitors on Wednesday nights in the past few years wins with his personal recut sails from Bacons. He probably starts racing with sails as good as the top of the Wed night fleet or a bit worse. He knows how to set them right. His sails are good enough so that other aspects of racing determine his place but always in the top. But, he does not race CBYRA weekend races where the sailors would be as good as him, but playing with newer sails.

So bottom line: sails are an issue when we have boat speed issues that are not explained by some other factor like crew weight, bottom not clean, rig out of tune, etc. In the same breeze, current, etc. and with clear air and the other boat is just faster, then we might see and identify the problems in our sails.